Pioneer STZ-D10T-G - Manual (Page 8)

8 En
Before you start
Before using the remote control
The battery supplied with this unit is stored in the battery casing. Remove the protective seal from the battery casing.
Note
When you notice a decrease in the operating range, replace the battery.
Replace the battery
When replacing the battery, use a commercially available Lithium CR2025 battery.
1
1
3
2
WARNING
About lithium battery
! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.
! Dispose of used battery cells immediately after replacement. Keep away from children.
! If swallowed, please contact a doctor immediately.
! Lithium batteries may present a fire or chemical burn hazard if misused. Do not disassemble, heat above 100 °C, or incinerate.
! Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the life or performance of batteries.
CAUTION
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:
! Remove the battery if the unit isn’t going to be used for a month or more.
! When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your
country or area.
“ Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.) “
1 Flip the remote control and pull out the battery holder by pushing the tab to the right.
2 Place a new battery in the casing.
Make sure the + side of the battery is facing up when you place it in the space provided.
3 Push back the battery holder.