Pioneer RCS-55 - Manual (Page 6)

Speaker Setup Guide
6
En
Speaker Setup Guide
Safety precautions when setting up
When assembling the speakers, lay them down flat on
their side to avoid accidents or injury. Make sure to use a
stable surface when assembling, setting up, and placing
the speakers.
• Attach the smaller non-skid pads to the base of
each of the front speakers and the center speaker.
The four large non-skid pads are for the receiver
subwoofer (as shown).
Use the supplied adhesive to attach 4 pads to the base
(flat surface) of each speaker.
Home theater sound setup
Depending on the size and characteristics of your room,
you can place your speakers in one of two ways using this
system: 1
• Standard surround 5-spot setup – This is a
standard multichannel surround sound speaker
setup for optimal 5.1 channel home theater sound.
• Connect the speaker system.
Refer to Connecting up to connect the speakers properly.
Place them as shown in the diagram above for optimal
surround sound.
After placing your speakers, complete Channel level
setting on page 27 then refer to Speaker distance setting
on page 27 to complete your surround sound setup.
Non-skid pads
(small) x 12
Front speakers Center speaker
Non-skid pads
(large) x 4 Receiver
subwoofer
Note
1 See About the listening modes on page 22 for more on using the different listening modes with each speaker setup.
Surround
left
Surround
right
Listening position
Receiver subwoofer Center
Front
left
Front
right
Introduction.book Page 6 Friday, July 8, 2005 2:28 PM