Pioneer RCS-55 - Manual (Page 85)

The Initial Setup menu 08
85
En
English
From the Audio In screen, use the / buttons to select
a setting, then use the / buttons to adjust it.
• NICAM Select – If you want to record the non-NICAM
audio in a TV broadcast, select Regular Audio ,
otherwise set to NICAM . (When set to NICAM , you
can still select Regular Audio using the AUDIO
button. See Changing audio channels on page 51.)
• Tuner Level – Set to Compression if the audio level
from the built-in tuner is excessively high causing
distortion.
• External Audio – Select Stereo if the external audio
input is regular stereo, or Bilingual if each channel
carries a separate soundtrack.
• Bilingual Rec – When recording a bilingual source
from an external input in Video mode or VR mode set
to
XP , you can choose to record either the A/L (left),
or the B/R (right) audio channel.
Note
• Except in XP recording mode, if you’re recording in
VR mode, both channels will be recorded and you
can switch them as you like on playback.
Audio Out
Use the various Audio Out settings to make sure that the
digital audio output is compatible with the receiver
subwoofer (or other connected component). You may
need to check the operating instructions that came with
the connected component to see which digital formats
it’s compatible with.
From the Audio Out screen, use the / buttons to
select a setting, then use the / buttons to adjust it.
• Dolby Digital – If the connected component is Dolby
Digital compatible, set to Dolby Digital , otherwise
set to Dolby Digital -> PCM .
• 96kHz PCM – If the connected component is
compatible with high sampling rate audio (88.2 / 96
kHz), set to
96kHz , otherwise set to 96kHz -> 48kHz .
• DTS – If the connected component has a built-in DTS
decoder, set to On , otherwise set to Off . (See also
Important below.)
• MPEG – If the connected component is MPEG audio
compatible, set to MPEG , otherwise set to MPEG ->
PCM .
Important
• If you set DTS to On with a non-DTS compatible
amplifier, noise will be output when you play a DTS
disc.
• When set to On , there is no analog audio output
when playing a DTS DVD-Video disc.
• When playing a DTS audio CD (even when DTS is
Off ), noise is output from the analog outputs. Do not
play this through your amplifier and speakers.
• When playing a DTS audio CD, make sure that
Stereo is selected using the AUDIO button. See
Switching DVD soundtracks on page 61.
Recording settings
Optimized Rec
• Default setting: Off
Audio In
Stereo
Normal
A/L
External Audio
NICAM
Bilingual Rec
Tuner Level
NICAM Select
Basic
Disc
Video
Audio
Recording
Playback
Dolby Digital
96kHz PCM
DTS
MPEG
Audio
Audio Adjust
Audio In
Audio Out
Audio Out
Dolby Digital
96kHz PCM
DTS
MPEG
96kHz -> 48kHz
On
MPEG -> PCM
Dolby Digital
Basic
Disc
Video
Audio
Recording
Playback
Optimized Rec
Auto Chapter
DVD-RW Auto Init
Recording
DVR-230_UK.book Page 85 Thursday, July 7, 2005 7:20 PM