Installation, Din front/rear-mount, Removing or attaching the trim ring – Pioneer DEX-P99RS User Manual

Page 10

Advertising
background image

10

Installation

Note

• Check all connections and systems before final

installation.

• Do not use unauthorized parts. The use of

unauthorized parts may cause malfunctions.

• Consult with your dealer if installation requires

drilling of holes or other modifications of the

vehicle.

• Do not install this unit where:

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

of a sudden stop.

• The semiconductor laser will be damaged if it

overheats. Install this unit away from hot places

such as near the heater outlet.

• Optimum performance is obtained when the unit

is installed at an angle of less than 60°.

DIN Front/Rear-mount

This unit can be properly installed either from

Front

(conventional DIN Front-mount) or

Rear

(DIN Rear-mount installation, utilizing

threaded screw holes at the sides of unit
chassis). For details, refer to the following
installation methods.

Removing or attaching
the trim ring

1. Extend top and bottom of the trim ring

outwards to remove the trim ring.

• When reattaching the trim ring, push the trim

ring onto the unit until it clicks. (If the trim ring

is attached upside down, the trim ring will not

fit properly.)

• It becomes easy to remove the trim ring if the

front panel is released.

Trim ring

Advertising