English setting up surround cube speakers, Acoustimass module – Bose VCS 10 Series II User Manual

Page 10

Advertising
background image

8 October 22, 2001 AM19464_02_V.pdf

English

Setting Up

Surround cube speakers

The left and right rear channel sound should reach the viewer from both sides, rather than
from directly behind. Refer to Figure 5.

• Put one on the left and the other on the right, beside or just to the rear of the home theater

seating area.

• Place them high up, to avoid a direct sound path to the ears of the listeners (position 1).

• If you want the speakers located as shown in positions 2 and 3, make sure they are not

directed at the viewers.

• The rear speaker on the left as you face the TV is connected to the LEFT SURROUND

output jack on the Acoustimass

®

module.

Figure 5

Suggested choices for surround
(rear) speaker placement

Acoustimass module

Bose

®

recommends putting your Acoustimass module at the same end of the room as the

television monitor. To prevent interference, keep the module at least 2 feet (.6 m) from the
television.

• You may hide the Acoustimass module behind or under furniture, but do not block the

opening. Be sure there is at least 2 inches (5 cm) between the opening and any surface.

• If the opening faces the wall it increases the bass; if it faces away it decreases the bass.

For the most bass response, place the opening 2 to 3 inches (5 to 8 cm) from a wall or
corner.

• Stand the Acoustimass module vertically or horizontally (Figure 6). To stand it on the

cable connection end, remove the cover by gently pulling it away.

After selecting a place for the Acoustimass module, attach the larger set of four rubber feet
to the bottom surface for additional stability. The feet protect the cable connections and
must be mounted when the Acoustimass module is standing on that end.

1

2

3

1

2

3

Figure 6

Acoustimass module positions

Advertising