Bose VCS 10 Series II - Manual (Page 11)

AM194646_02_V.pdf October 22, 2001 9
English
Connecting the speakers
The supplied cables make it easy for you to connect your system. The connections at the
Acoustimass
® module are already made for you. There are three sets of cables, joined
together to form ribbons, which may be separated or “unzipped” as much as needed to
comfortably reach the speakers (Figure 7). Separate the cables as you are laying out the
cable lengths.
• The 20 foot (6 m) cable with three pairs of wires connects the Acoustimass module to the
center, left, and right front cube speakers.
• The 50 foot (15 m) cable with two pairs of wires connects the Acoustimass module to the
left and right surround cube speakers.
• The 20 foot (6 m) cable with five pairs of wires connects the Acoustimass module to the
outputs on the receiver. Separate these wires just enough to reach the connectors.
Figure 7
Separating cables
Setting Up
CAUTION: Before making any connections turn off your receiver or amplifier and unplug it
from the outlet (AC power mains). Not doing so may result in damage to your system.
Never connect the cubes directly to a receiver output. Always connect the cube speakers to
the Acoustimass module, then connect the Acoustimass module to the receiver.
Never use broken or frayed wiring, which can result in electrical shock or damage to your
system.
The supplied cables are not intended for in-wall installation. Check local building codes or
enlist a qualified installer.