Toshiba Tecra A5 - Manual (Page 153)

TOSHIBA A5 9-14
Troubleshooting
TV output signal
Standby/Hibernation
Real Time Clock
Problem Procedure
Display on TV is poor Make sure the TV type is correct for your area:
NTSC (US) or PAL (Europe).
No display Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5,
The Keyboard .
If problems persist, contact your dealer.
If you turn the computer off in Standby Mode while the display is on a TV,
the computer will select either the internal LCD or an external computer CRT
as the display device the next time it is switched on.
Problem Procedure
The system will not
enter Standby/
Hibernation Is Windows ® Media Player open? The system
might not enter Standby/Hibernation, if
Windows
®
Media Player is either playing a
selection or finished playing a selection. Close
Windows
®
Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Problem Procedure
The RTC battery
charge has become
exhausted, you should
set the date and time in
within the BIOS setup
screen through the
following steps:
RTC battery is low or
CMOS checksum is
inconsistent. Press
[F2] key to set Date/
Time.
The following message is displayed on the LCD:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].