Toshiba Satellite Pro P100 (PSPAE) - Manual (Page 139)

User’s Manual 9-13
Troubleshooting
TV output signal
Standby/Hibernation
Real Time Clock
Problem Procedure
Display on TV is poor Make sure the TV type is correct for your area:
NTSC (US) or PAL (Europe).
No display Try adjusting the contrast and brightness controls
on the external monitor.
Press hotkeys Fn + F5 to change the display.
Refer to Chapter 5, The Keyboard .
If problems persist, contact your dealer.
If you turn the computer off in Standby mode while the display is on TV, the
computer will select either the internal LCD or an external computer CRT
as the display device.
Problem Procedure
The system will not
enter Standby/
Hibernation
Is Windows ® Media Player open? The system
might not enter Standby/Hibernation, if
Windows
® Media Player is either playing a
selection or finished playing a selection. Close
Windows
® Media Player before you select
Standby/Hibernation.
If problems persist, contact your dealer.
Problem Procedure
The following message
is Displayed on the
LCD:
RTC battery is low or
CMOS checksum is
inconsistent. Press [F2]
key to set Date/Time.
The battery for RTC is wearing. Set the date and
time in BIOS setup with the following steps:
1. Press [F1] key. BIOS setup will boot up.
2. Press [F2] to set the date in [System Date].
3. Press [F2] to set the time in [System Time].