Starting the computer by password, Starting the computer by password -11, Installing the battery pack – Toshiba SATELLITE U500 User Manual

Page 135

Advertising
background image

User’s Manual

6-11

Satellite U500/U500D, Satellite Pro U500/U500D

Installing the battery pack

To install a battery, follow the steps below.

1. Turn the computer’s power off.

2. Disconnect all cables connected to the computer.

3. Insert the battery pack.

4. Ensure the battery pack lock is moved into its locked position.

Figure 6-3 Securing the battery pack

Starting the computer by password

To start up the computer with the user password, follow these steps:

1. Turn on the power as described in Chapter 3,

Getting Started

. The

following message appears:

2. Enter the password.

3. Press Enter.

The battery pack is a lithium ion battery, which can explode if not
properly replaced, used, handled or disposed of. Dispose of the battery
as required by local ordinances or regulations. Use only batteries
recommended by TOSHIBA as replacements.

Do not touch the battery release latch while holding the computer or the
battery pack might fall out due to the unintentional release of the
battery release latch and cause injuries.

1

2

1.

Battery Pack Lock

2.

Battery Pack

Password=

At this point, the hotkeys Fn + F1 to F9 do not work. They will function after
you enter the password.

If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.

Advertising
This manual is related to the following products: