Lan wireless lan – Toshiba SATELLITE U500 User Manual

Page 173

Advertising
background image

User’s Manual

9-19

Satellite U500/U500D, Satellite Pro U500/U500D

LAN

Wireless LAN

If the following procedures do not restore LAN access, consult your LAN
administrator. For more information on wireless communication, refer to
Chapter 4,

Operating Basics

.

After making a call
you can’t hear a ring

Make sure the tone or pulse selection in your
communications application is set correctly.

You can also use the ATD command.

Communication is cut
off unexpectedly

The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.

A CONNECT display
is quickly replaced by
NO CARRIER

Check the error control setting in your
communications application.

You can also use the AT\N command.

Character display
becomes garbled
during a
communication

In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.

Check the flow control and communication
protocol.

You cannot receive an
incoming call

Check the rings before auto answer setting in
your communications application.

You can also use the ATS0 command.

If problems persist, contact your dealer.

Problem

Procedure

Problem

Procedure

Cannot access LAN

Check for a firm cable connection between the
LAN jack and the LAN hub.

If problems persist, consult your LAN
administrator.

Problem

Procedure

Cannot access
Wireless LAN

Make sure the computer’s wireless
communication switch is set to on.

If problems persist, contact your LAN
administrator.

The Wireless LAN feature is not available on all models.

Advertising
This manual is related to the following products: