Toshiba Portege Z930-F User Manual
Page 108
3.
Insert the first blank disc into the optical disc drive tray, or Insert the
USB Flash Memory into one available USB port.
4.
Click Desktop -> Desktop Assist -> Support & Recovery ->
Recovery Media Creator.
5.
After Recovery Media Creator starts, select the type of media and the
title you wish to copy, and then click the Create button.
Restoring the pre-installed software from your created
Recovery Media
If the pre-installed files are damaged, you are able to use the Recovery
Media you have created to restore the computer to the state it was in when
you originally received it. To perform this restoration, follow the steps
below:
When you reinstall the Windows operating system, the hard disk will
be reformatted and all data will be lost.
Please make sure to use the default Boot Mode option in the BIOS
setup utility before restoring.
To start BIOS Setup, press and hold the F2 key, and then turn on the
computer. Release the F2 key one second after the computer is power
on. If your computer does not load the Recovery options, please refer
to the
section.
In the BIOS setup screen, select Advanced -> System Configuration
-> Boot Mode -> UEFI Boot (Default).
If you set the Boot Mode as CSM Boot, the recovery media created by
Recovery Media Creator will NOT be able to restore.
If you create a recovery image using advanced recovery tools from
Control Panel, please also make sure to use the default Boot Mode
option (UEFI Boot) in the BIOS setup utility before restoring.
1.
Load the Recovery Media into the external Optical Disc Drive or insert
the recovery USB Flash Memory into one available USB port.
2.
Turn off the computer's power.
3.
While holding down the F12 key on the keyboard, turn on your
computer. Release the F12 key one second after the computer is
power on.
4.
Use the up and down cursor key to select the appropriate option from
the menu according to your actual recovery media. Please refer to the
section for further information.
5.
A menu will be displayed from which you should follow the on-screen
instructions.
If your computer does not load the Boot menu, please refer to the
User's Manual
5-20