Toshiba Satellite L30 (PSL30) - Manual (Page 89)

User’s Manual 6-10
Power and Power-Up Modes
■ The condition of the battery terminals. Make sure the battery terminals
stay clean by wiping them with a clean dry cloth before installing the
battery pack.
Retaining data with power off
When you turn off your computer with fully charged batteries, the batteries
retain data for the following approximate time periods.
Extending battery life
To maximize the life of your battery pack:
■ At least once a month, disconnect the computer from a power source
and operate it on battery power until the battery pack fully discharges.
Before doing so, follow the steps below.
1. Turn off the computer's power.
2. Disconnect the AC adaptor and turn on the computer's power. If it does
not turn on go to step 4.
3. Operate the computer on battery power for five minutes. If the battery
pack has at least five minutes of operating time, continue operating until
the battery pack is fully discharged. If the Battery indicator flashes or
there is some other warning to indicate a low battery, go to step 4.
4. Connect the AC adaptor to the computer and the power cord to a power
outlet. The Battery indicator should glow orange to indicate that the
battery pack is being charged. If the Battery indicator does not glow,
power is not being supplied. Check the connections for the AC adaptor
and power cord.
5. Charge the battery pack until the Battery indicator glows green.
■ If you have extra battery packs, rotate their use.
■ If you will not be using the system for an extended period, more than
one month, remove the battery pack.
■ Disconnect the AC adaptor when the battery is fully charged.
Overcharging makes the battery hot and shortens life.
■ If you are not going to use the computer for more than eight hours,
disconnect the AC adaptor.
■ Store spare battery packs in a cool dry place out of direct sunlight.
Battery pack About 1 days (Standby mode)
About 30 days (Boot mode)
RTC battery 30 days