Ant/cable/satellite (if available) – Toshiba L4363 User Manual
Page 20
20
En
g
lis
h
SETTING UP YOUR TV
x
If the reception testing completes successfully, the
Auto Tuning
startup screen will display.
You can select Search Option from Free to Air or
All
.
When choosing the search option All, all channels
(including encrypted ones) of the satellite will be
searched for. If you wish to only search for
unencrypted (free) channels, please select Free to
Air
. In this case, the channel scan will be
completed faster.
y
Press
b
to highlight Start Scan, and press OK.
The television will start to search for available
DVB-S
channels. The progress bar will indicate
the scan status.
When the search is complete, the Auto Tuning
results screen will display the total number of
services found.
z
Use
B
/
b
to move through the list to select a
channel, and then press OK to view.
From this menu, you can set the RF input configuration.
a
Press
and
B
/
b
to highlight Installation
icon.
b
Press
c
and
B
/
b
to select Channel Tuning and
press OK.
c
Press
B
/
b
to select Ant/Cable/Satellite and
press OK.
d
Press
B
/
b
to select Antenna, Cable or
Satellite
.
e
Press
B
/
b
to highlight Next and press OK.
NOTE:
When you attempt to change the Ant/
Cable/Satellite
setting, a warning message will
appear followed by PIN entry (if PIN has been set)
and a prompt for Auto Tuning.
f
When Ant/Cable/Satellite is set to Cable, the
following setting options will be provided in the
Auto Tuning
screen.
Press
B
/
b
to select an item and press
c
and
B
/
b
to select your desired option.
With the exception of DTV Scan Type and DTV
Modulation
items, all of the following items will have 2
operating modes. The first is Auto where the values for
each item are preset by the system. The second is an
Input
mode where you will be able to enter a single value
in place of the pre-set value. If no channel is currently
tuned and the Input state is chosen, a system default
value will be shown. However, if a channel is currently
tuned when the item is accessed, the value of the current
channel will be displayed.
Operator Selection:
You can choose the Cable operator depending on the
Country
you set.
DTV Scan Type:
This item determines whether a Quick Scan or a Full
Scan
will be executed.
The Quick Scan is a simplified version of the Full Scan
that is designed to complete in less time.
DTV Start Frequency:
This sets the frequency from which the scan will begin.
DTV End Frequency:
This sets the frequency at which the scan will end.
DTV Modulation:
You can choose from five QAM modulation settings.
DTV Symbol Rate:
This is the baud rate (KS/s) of the scan.
DTV Network ID:
This is the Network ID to be utilized for the scan. This item
is greyed out when DTV Scan Type is set to “Full Scan”.
PLEASE NOTE
The Quick Setup menu can also be accessed at
any time from the Installation menu.
Ant/Cable/Satellite (if available)
Scan Type
Quick Scan
Search Option
Free to Air
Auto Tuning - Satellite
Start Scan
Tuning Mode
DTV and ATV
Auto Tuning - Cable
Start Scan
DTV
Operator Selection
Others
Scan Type
Quick Scan
Start Frequency
Auto
End Frequency
Auto
Modulation
Auto
Symbol Rate
Auto
Network ID
Auto