Toshiba L4363 - Manual (Page 8)

8
En
gli
s
h
CONNECTING YOUR TV
Connecting external equipment
Before connecting any external equipment, turn off all main power switches. If there is no
switch, remove the mains plug from the wall socket.
Aerial cables: . . . . . . . . . . . . . . . . . . . . . . . .
Connect the aerial to the socket on the rear of the TV.
If you use a decoder and/or a media recorder, it is
essential that the aerial cable is connected through the
decoder and/or through the media recorder to the TV.
Satellite cable: . . . . . . . . . . . . . . . . . . . . . . .
Connect the LNB from the satellite dish to the SATELLITE
ANTENNA socket on the TV. You can receive TV, radio,
interactive TV, and HD TV with clear reception.
SCART leads: . . . . . . . . . . . . . . . . . . . . . . . .
Connect the media recorder IN/OUT socket to the
television.
Connect the decoder TV socket to the television.
Before running Auto Tuning, put your decoder and media
recorder to Standby.
The RCA sockets alongside the COMPONENT VIDEO
INPUT sockets will accept L and R audio signals.
When connecting the VIDEO/AUDIO devices, connect
those cables to Y/L/R sockets.
The Digital Audio Output socket enables the connection of
a suitable surround sound system.
NOTE: This output is always active.
HDMI
®
(High-Definition Multimedia Interface) is for use
with electrical equipment with digital audio and video
output. It is designed for best performance with 1080i and
1080p high-definition video signals but will also accept
and display VGA, 480i, 480p, 576i, 576p and 720p
signals.
PC format signals will also be displayed.
NOTE: Although this television is able to connect to HDMI
equipment, it is possible that some equipment may not
operate correctly.
LAN port is used to connect the TV to your home network.
A wide variety of external equipment can be
connected to the back of the television; therefore, the
relevant owner’s manuals for all additional equipment
must be referred to for exact instructions.
If the television automatically switches over to monitor
external equipment, return to normal television by
pressing the desired programme position button. To recall
external equipment, press
o to select between TV,
EXT 1, EXT 2, HDMI 1, HDMI 2, HDMI 3, HDMI 4 or PC.
When the external input mode is selected while viewing
DTV mode, the SCART socket does not output video/
audio signals.
ILLUSTRATION SHOWS 32L.
Power cord
Satellite dish
Aerial Cable
* A Decoder can be digital Satellite, free to air or any
other compatible decoder / recorder.
Decoder*
LAN port
COMPONENT VIDEO/AUDIO INPUT
VIDEO/AUDIO INPUT (Y/L/R) (EXT 2)
SCART (EXT 1)
DVB Common Interface
(for Conditional Access
Module (CAM))
Headphones
HDMI (1~3)
USB (1~2)
HDMI 4 INPUT
DIGITAL AUDIO OUTPUT
(OPTICAL)
RGB/PC INPUT
LNB IN SATELLITE ANTENNA
(L436* series only)
Aerial