Toshiba Qosmio G50 User Manual

Page 173

Advertising
background image

User’s Manual

9-11

Qosmio G50

8. Seat the memory module cover in place and secure it with one screw.

Figure 9-8 Seating the memory module cover

9. Install the battery pack - refer to

Replacing the battery pack

section in

Chapter 6,

Power

, if required.

10. Turn your computer over.

11. Turn the computer on and make sure the added memory is recognized -

to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.

Removing a memory module

To remove the memory module, follow the steps as detailed below:

1. Shut down the computer - make sure the Power indicator is off (refer to

the

Turning off the power

section in Chapter 3,

Getting Started

, if

required).

2. Remove the AC adaptor and all cables and peripherals connected to

the computer.

3. Close the display panel.

4. Turn the computer upside down and remove the battery pack (refer to

Replacing the battery pack

section in Chapter 6,

Power

, if required).

5. Loosen the screw securing the memory module cover in place - please

note that this screw is attached to the cover in order to prevent it from
being lost.

6. Slide your fingernail or a thin object under the cover and lift it off.

7. Push the latches away from the module in order to release it - a spring

will force one end of the module up at an angle.

Take care to ensure that the memory module cover is firmly closed.

Screw

Memory module cover

The slot A is reserved for main memory. Use the slot B for expanded
memory. If only one card is installed, use the slot A.

Advertising