Toshiba Tecra A50-A - Manual (Page 89)

9. Install the battery pack - refer to Replacing the battery pack section, if
required.
10. Turn your computer over.
11. Turn the computer on and make sure the available memory is
recognized - to confirmed it, click Start -> Control Panel -> System and
Security -> System.
Installing/Removing a memory module (Slot C/D)
To install/remove a memory module (Slot C/D), follow the steps as detailed
below:
1.
Shut down the computer - ensure that the Power indicator is off.
2. Disconnect the AC adaptor, all cables, and any peripheral connected
to the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section, if required).
5. Remove the following KB screw used to keep the keyboard secure on
the underside of the computer.
Figure 4-15 Removing the KB screw
1
1. KB screw
Product appearance depends on the model you purchased.
6. Turn your computer over and open the display panel.
User's Manual 4-39