Toshiba Satellite L675D - Manual (Page 100)

User’s Manual 4-20
Operating Basics
■ TOSHIBA Disc Creator does not support recording to DVD-RAM discs - to
achieve this you should use Windows Explorer or another similar utility.
■ When you back up a DVD disc, be sure that the source drive supports
recording to DVD-R, DVD-R (Dual Layer), DVD-RW, DVD+R, DVD+R
(Double Layer) or DVD+RW media - if this is not the case then the
source disc might not be backed up correctly.
■ When you back up a DVD-R, DVD-R (Dual Layer), DVD-RW, DVD+R,
DVD+R (Double Layer) or DVD+RW disc, be sure to use the same type
of disc.
■ You cannot partially delete any data written to a CD-RW, DVD-RW or
DVD+RW disc.
Data Verification
To verify that data has been written or rewritten correctly to a data
CD/DVD/BD you should follow the steps below before you begin the
write/rewrite process:
1. Display the setting dialog box by one of the following two steps:
■ Click the Recording settings button ( ) for writing on the main
toolbar in the "Data CD/DVD" mode.
■ Select Settings for Each Mode  Data CD/DVD in the Settings
menu.
2. Mark the Verify Written data check box.
3. Select File Open or Full Compare mode.
4. Click the OK button.
How to learn more about TOSHIBA Disc Creator
Please refer to the Help files for additional TOSHIBA Disc Creator information.
■ Opening the TOSHIBA Disc Creator Manual Start  All Programs 
TOSHIBA  CD&DVD Applications  Disc Creator Help.
When Using Corel DVD MovieFactory for TOSHIBA
How to make a DVD-Video
Simplified steps for making a DVD-Video from adding video source:
1. Click Start  All Programs  DVD MovieFactory for TOSHIBA 
DVD MovieFactory Launcher to launch DVD MovieFactory.
2. Click Create Video Disc  New Project to invoke 2
nd
Launcher,
choose your project type, then invoke DVD MovieFactory.
3. Add source from HDD by click Add Video files button to invoke
browser dialog box.
4. Choose the source video then go to Next page to apply Menu.
5. After choose the menu template, press Next button to go to Burning Page.
6. Choose the output type then press Burn button.