Toshiba BV801 - Manual (Page 18)

English - 18 -
English
Controlling the TV
A wide variety of external equipment can be connected via the sockets located on the side and back of the
television. Whilst all the necessary adjustments and controls for the television are made using the remote
control, the buttons on the left side of the television may be used for some functions.
Switching on
If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the
button on the left
side of the television to switch the television on. Then the
LED lights up. If the picture does not appear, press
on
the remote control; it may take a few moments.
To put the television into Standby, press
on the remote
control. To view the television, press again. The picture
may take a few seconds to appear.
Note: The active Standby LED may appear for a few moments
when the TV is switched off.
For energy saving:
Turning the television off at its mains supply, or un-plugging
it, will cut energy use to nearly zero for all televisions. This
is recommended when the television is not being used for a
long time, e.g. when on holiday.
Reducing the brightness of the screen will reduce energy use.
Energy effi ciency cuts energy consumption and thus saves
money by reducing electricity bills.
NOTE: Putting the television into standby mode, will reduce
energy consumption, but will still draw some power.
Using the Remote Control
Press the MENU button on the remote control to see the
menus.
The main menu appears as a group of icons each for a menu
option. Press the
or button to select a topic, and press
OK button.
In sub menu screen mode the menu appears as a list. Press
the
or button to select a topic, and press OK button.
To use the options press the and buttons on the remote
control to move up and down through them and OK, or
buttons to select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
Using the control buttons of the TV
To alter the volume press + -.
• To alter the programme position press - P/CH + on the right
side of the TV.
• Press + - buttons at the same to view main menu and
use - P/CH + to navigate and + - to change value.
NOTE: The USB socket has limited functionality, and Toshiba
can take no responsibility for damage to other connected
equipment.
Please always refer to the owner’s manual of the equipment
to be connected for full details.
Menu OSD
Volume
Down/Up
Programme
Down/Up
AV/
Source
Standby
On/Off
Switch
White Standby LED
32&40BV801B_MB38_[GB]_(IB_INTERNET)_DVB-T2_(3910UK)_10073217_10073218.indd 18 32&40BV801B_MB38_[GB]_(IB_INTERNET)_DVB-T2_(3910UK)_10073217_10073218.indd 18 03.10.2011 18:53:04 03.10.2011 18:53:04