Initial installation, English – Toshiba BV801 User Manual

Page 19

Advertising
background image

English - 19 -

English

Initial Installation

Before switching on the television put your decoder and media recorder to Standby if they are connected

and ensure the aerial is connected to your television. To set up the television use the buttons on the remote

control as detailed on page 13.

IMPORTANT: Ensure that the aerial is connected and
a Common Interface module is not inserted before
switching on the TV for the fi rst time installation.

Connect the mains plug and switch the TV into

1.

on using the side standby switch. If the TV does
not switch on, press any numbered or standby
button on the remote control, then the following
menu will be displayed. This screen will appear
the fi rst time that the television is switched on and
each time the television is reset.

Select

2. Yes by using Left or Right buttons and

press OK to continue.
The automatic channel scan screen will appear

3.

and the television will start to search for available
stations. The progress bar will move along the
line. You must allow the television to complete
the search. The following OSD will be displayed
on the screen and the television will search for
digital TV broadcasts:

Note: You can press MENU button to cancel.

After

4. Automatic

Search is completed, the

following message, asking for analogue channel
search, appears on the screen.

Select your

5. Country,

Language and Text

language by using navigation buttons. Press
OK or RED button to continue. To cancel, press
the BLUE button.

Note :

For proper functioning of digital teletext in DTV

mode, you should set country as UK in analogue
AUTO PROGRAM .
Do not turn off the TV while initializing fi rst time

installation.
After

automatic channel scan is finalized, a

programme list will appear on the screen. In the
programme list you will see the programme numbers
and names assigned to the programmes.
If you do not accept the locations and/or the names

of the programmes, you can change them in program
table.

32&40BV801B_MB38_[GB]_(IB_INTERNET)_DVB-T2_(3910UK)_10073217_10073218.indd 19

32&40BV801B_MB38_[GB]_(IB_INTERNET)_DVB-T2_(3910UK)_10073217_10073218.indd 19

03.10.2011 18:53:04

03.10.2011 18:53:04

Advertising