Toshiba SDP94D - Manual (Page 30)

30
P
repar
ations
Preparation of the remote control
Insert the specified battery to the remote control. See
page 8 for safe use of coin-shaped batteries.
1 Gently insert a fingernail in groove 1
and pull out the holder in direction 2 .
Take care not to break your fingernail.
2 Place a coin-shaped
battery (CR2025) with the
㧗 side up on the holder.
Keep the holder horizontal so that
the battery does not fall through.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.
3 Insert the holder into the remote control.
The remote control battery contains Perchlorate
Material - special handling may apply.
Operating with the remote control
Point the remote control at the remote sensor and press
the buttons.
Distance: About 3 m (9.9 feet) from the front of the remote
sensor
Angle: About 30° in each direction of the front of the
remote sensor
Do not expose the remote sensor of the player to a strong light
source such as direct sunlight or other illumination. If you do
so, you may not be able to operate the player via the remote
control.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
• If the remote control does not function correctly or if the operating
range becomes reduced, replace the battery with new one.
• Inserting a battery other than the specified one or an object may
damage the remote control.
    2 #
6 
Backside
1
2
Within about 3 m (9.9 feet)
SDP94DTWB_E_01-56.indd 30 SDP94DTWB_E_01-56.indd 30 2010/06/03 9:30:38 2010/06/03 9:30:38