Toshiba DR20 - Manual (Page 12)

12 EN
Installing Batteries in the Remote
Control
Install 2 R6 (1.5 V) batteries (supplied) into the remote
control, carefully match with the polarity indicated inside the
battery compartment.
Caution
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used for a
month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
• Make sure there is no obstacle between the remote control
and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
• The maximum operable range as follows:
• Remote control operation may become unreliable if the
remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.
• Remote controls for different devices can interfere with each
other. Be careful when using remote controls for other
equipment located close to the unit.
• Replace the batteries when the operating range of the
remote control reduces.
Guide to On-Screen Displays
With a disc inserted into the unit, press [DISPLAY] to display
the on-screen display. The on-screen display shows
information about what is recorded on the disc.
This is an example screen for explanation. Displayed items
vary depending on the actual mode.
1 Indicates a disc type and format mode.
2 Indicates a type of titles for VR mode DVD-RW
disc.
3 Indicates a channel number, station name
(analogue channel only) or selected external
input mode.
4 Indicates a recording mode and possible
recording time left.
5 Indicates a title number, chapter number,
elapsed time and total of disc playback.
6 Each icon means:
7 Indicates an operation status.
Note
• For some descriptions on this manual, only one disc type is
indicated as an example.
About the Remote Control
Line of sight: approximately 7 m
Either side of centre: approximately 7 m within 30 degrees
2 1 3
Within
about 7 m
7 m (30°) 7 m 7 m (30°)
DISPLAY Menu
: Search
: Audio
: Subtitle
: Angle
: Repeat
: Marker
: Noise Reduction
: Zoom
: Surround
1/ 5 1/ 5
-RW VR ORG
0:01:00 / 1:23:45
2 2
5 5
6 6 1 1
3
7
1 BBC1
T C
SP 1:53 4
E7TE0BD_EN.book Page 12 Friday, March 5, 2010 5:08 PM