Starting the computer by password, Power-up modes – Toshiba NB100 User Manual
Page 72
User’s Manual
6-11
Power and Power-up Modes
Starting the computer by password
If you have already registered a password, please enter the password
manually to start the computer:
To start up the computer with the user password, follow these steps:
1. Turn on the power as described in Chapter 3,
The following message appears:
Username
2. Enter the password.
3. Press Enter.
Power-up modes
The computer has the following power-up modes:
■
Boot: Computer shuts down without saving data. Always save your
work before you turn the computer off in boot mode.
■
Hibernation: Data in memory is saved to the hard disk.
■
Standby: Data is maintained in the computer’s main memory.
Hot keys
You can use hot keys Fn + F2 to enter hibernation mode. See Chapter 5,
for details.
Panel power on/off
You can set up your computer so that power turns off automatically when
you close the display panel. When you open the panel, power turns on in
standby or hibernation mode but not in boot mode.
System auto off
This feature turns the system off automatically if it is not used for a set
duration. The system shuts down in standby mode or hibernation mode.
At this point, the hot keys Fn + F1 to F9 do not work. They will function
after you enter the password.
Refer also to the sections
and
in Chapter 3,
.
If the panel power off function is enabled and use Shut down Windows, do
not close the display until the shut down function is completed.