How to use the floor and utility brushes, Applying detergent with the adjustable nozzle, Caution – Briggs & Stratton 020239-0 User Manual
Page 11
SpeedClean™ 2200 PSI Pressure Washer
11
2.
Point nozzle down towards a firm surface and press
trigger to test spray pattern (Figure 10).
3.
Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure 11).
Usage Tips
• For most effective cleaning, keep spray nozzle from 8 to
24 inches away from cleaning surface.
• If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
• DO NOT get closer than 6 inches when cleaning tires.
How to Use the Floor and Utility
Brushes
The floor and utility brushes allow you to scrub surfaces
with water filtering through the bristles.
To attach the utility brush to the gun:
1.
Tighten the adapter to the brush base.
2.
Remove the nozzle extension from the spray gun, if
attached.
3.
Attach the brush with the adapter to the spray gun.
Tighten by hand (Figure 12).
NOTE: You must use the adapter to attach the brush to
the spray gun.
To attach the floor brush to the gun:
1.
Tighten the adapter to the brush extension.
2.
Remove nozzle extension from spray gun, if attached.
3.
Attach brush extension to spray gun.Tighten by hand.
4.
Attach floor brush to brush extension (Figure 13).
Tighten by hand.
NOTE: You must use the adapter to attach the brush
extension to the spray gun.
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent, follow these steps:
1.
Review use of adjustable nozzles.
2.
Prepare detergent solution as required by job.
3.
Place filter end of chemical injection hose into
detergent container.
CAUTION
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
You must attach all hoses before you start the engine.
CAUTION
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
Keep the chemical injection tube from coming in contact
with the hot muffler.
Figure 10 — Testing the Spray Pattern
Figure 12 - Attaching Utility Brush to Spray Gun
Figure 13 - Attaching Floor Brush to Spray Gun
Figure 11 — Adjusting the Nozzle for Spray Pattern
Clockwise = Narrow Spray
Pattern
Counterclockwise = Fan
Spray Pattern