Briggs & Stratton 020239-0 - Manual (Page 7)

SpeedClean™ 2200 PSI Pressure Washer
7
Install Wheel Kit
The wheel kit is designed to greatly improve the portability
of your pressure washer.
NOTE: Wheel kit is not intended for over-the-road use.
Refer to Figure 2 and install the wheel kit as follows:
1.
Place the bottom of the pressure washer frame on a flat,
even surface.Temporarily place unit on blocks to ease
assembly.
2. Slide axle through holes in frame, as shown in Figure 2.
3. Slide a wheel over the axle.
NOTE: Be sure to install wheel with raised hub inward.
4. Retain wheel on axle stud with retaining pin.
5. Repeat step 3 and 4 to secure second wheel.
6. Remove the temporary blocks.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
• Refer to engine owner’s manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine owner’s manual for recommendations.
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
Figure 2 — Install Wheel Kit