Nokia 6136 - Manual (Page 44)

G e t s t a r t e d
11
6. Replace the battery by positioning it (with the
label side facing up) so the gold-colored
contacts match up with those on the phone.
Slide the battery in until it snaps into place.
7. Slide the back cover until it locks into place.
■ Charge the battery
Warning: Use only batteries, chargers, and enhancements approved by
Nokia for use with this particular model. The use of any other types may
invalidate any approval or warranty, and may be dangerous.
This device is intended for use with the BL-4C battery. Always use original Nokia
batteries. See ”Nokia battery authentication guidelines,” p. 81.
Check the model number of any charger before use with this device. This device is
intended for use when supplied with power from the AC-4 charger.
For availability of approved enhancements, please check with your dealer.
1. Connect the charger to a standard
wall outlet.
2. Insert the charger plug into the
round jack in the bottom of the
phone. If the battery is completely
discharged, it may take a few
minutes before the charging
indicator appears on the display or
before any calls can be made.
3. Disconnect the charger from
the phone when the battery is
fully charged.
You can use the phone while the charger is connected. The charging time depends
on the charger and the battery used. For example, charging a BL-4C battery with
the AC-4 charger takes approximately 1 hour and 10 minutes while the phone is
in the standby mode.
6
7