Black Box ACU2222A - Manual (Page 37)

SERVSWITCH BRAND CATX KVM EXTENDER FAMILY
36
4.5 Other Remote Configuration &
Operation Options
Reset Commands
The ServSwitch Brand CATx KVM Extender Series has a number of commands to reset the
keyboard and mouse, to reset EQ and Delay values and to restore the factory default
configuration.
Command Key Sequence
Reset Mouse and Keyboard <F1>
Resets the keyboard and mouse and then automatically exits Command Mode. Use if the
mouse or keyboard locks up or the mouse does not initialize correctly.
Send NULL Mouse Byte <F3>
Use this command if you experience erratic movement of the mouse pointer. These can
occur when the mouse signal synchronization is lost. The command sends a null mouse byte
to the system and then automatically exits Command Mode. You may need to enter the
command a number of times to re-synchronize the mouse signal. Alternatively, stop moving
the mouse for a few seconds and the operating system’s mouse drivers may automatically
re-synchronize the signal.
Reset EQ Values <Left Control> + <End>
You can use this command to zero HF & LF EQ values for the selected video channel(s).
Current color delay values are not affected.
Reset EQ & Delay Values <Left Control> + <Home>
Set all video EQ (HF & LF) and color delay values to zero for the currently selected video
channel(s).
You can use this command to reset EQ and delay values for both video channels in a dual-
head installation by selecting Channel 0 prior to issuing this command.
Set Extender To Default State <Left Control> + <F9>
Sets ALL extender settings (video & configuration) back to the factory defaults and then
exits Command Mode.