Brother HL-3040CN - Manual (Page 19)

19
Other Information
Shipment of the printer
If for any reason you must ship your printer, carefully
package the printer to avoid any damage during
transit. We recommend that you save and use the
original packaging. The printer should also be
adequately insured with the carrier.
CAUTION
When shipping the printer, the DRUM UNIT,
TONER CARTRIDGE assemblies and WASTE
TONER BOX must be removed from the printer
and put in a plastic bag. Failure to remove these
items and put them in a plastic bag before shipping
may cause severe damage to the printer and may
VOID THE WARRANTY.
Repacking Instructions
Make sure that you have the following parts for
repacking.
a Plastic bags - to be supplied by you, the user; one for
the waste toner box, and one each for the four drum and
toner cartridge assemblies
b Protective covers that the original drum and toner
cartridge assembly came with
c Packing material for locking the belt unit
WARNING
This printer is heavy and weights approximately
41.9 lb. (19.0 kg). To prevent injuries use at least
two people to lift the printer. Be careful not to
pinch your fingers when you put the printer back
down.
a
Turn off the printer power switch, and then
unplug the AC power cord.
b
Open the top cover and take out all the drum
unit and toner cartridge assemblies.
Attach the protective cover to each of the drum unit
and toner cartridge assemblies.
Put each assembly into a plastic bag and completely
seal each bag.
c
Remove the belt unit by holding the green
handle and lifting the belt unit up and out of the
printer.
d
Remove the waste toner box from the printer,
and then put it in a plastic bag and seal the bag
completely.