Sharp CS-2635RHGY - Manual (Page 6)

4
POWER ON SWITCH:
When the “I” side of the power on
switch is pressed, the calculator is
turned on.
OFF POWER OFF KEY:
When the power off key is pressed,
the calculator is turned off.
PRINT / ITEM COUNT MODE
SELECTOR:
“
•”: Set to the non-print mode.
(“• • • ... • • • –P” will be printed.)
“P”: Set to the print mode.
(“• • • ... • • • +P” will be printed.)
“P•IC”: Set to the print and item
count mode.
The counter will count the
number of times that
has
been pressed in addition.
Notes: • Each time is used in
subtraction, 1 will be
subtracted from the count.
• The count is printed when the
calculated result is obtained.
• Pressing of , or
clears the counter.
OPERATING CONTROLS
• The counter has a
maximum capacity of 3
digits (up to ±999).
If the count exceeds the
maximum, the counter will
recount from zero.
RATE SETTING MODE SELECTOR:
This selector is used to set the conver-
sion rate or the tax / discount rate.
“ ”: Set this selector to the “RATE
SET” position before storing an
each rate.
Conversion rate:
• Enter the conversion rate,
then press .
• A maximum of 6 digits can be
stored (decimal point is not
counted as a digit).
Tax / discount rate:
• Enter the adding tax rate, then
press .
• To store a discount rate, press
before pressing .
• A maximum of 4 digits can be
stored (decimal point is not
CS-2635RH(AXO)-Eng 12.6.20, 8:40 AM Page 4 Adobe PageMaker 6.5J/PPC