Sharp LC-50LE771K - Manual (Page 8)

English - 7 -
Package Contents
4
7 8 9
0
1
.,/@
2 3
5 6
OK
Q.MENU
EXIT BACK
LANG.
2 1
SOURCE
/ /
P+
P-
V+
V-
P
V
P
BACK MENU
SOURCE
V
Remote Control 1-2
LED TV
Batteries: 4 X AAA
Quick Guide 1 X Video & Audio
Connection Cable
4 x 3D Glasses USB receiver
Note: You should check the accessories after purchasing.
Make sure that each accessory is included.
As the manufacturer’s specification supports
communication on cable lengths shall be smaller
than 3m.
TV Control button & Operation
1. Standby / On button
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons
Note: Press Volume Up/Down buttons at the same to view
main menu and use Prpgramme Up/Down buttons to navigate
and Volume Up/Down buttons to change value.
, switch is used for turning the TV on or off.
The position of the control buttons and power switch
may differ depending on the model.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable/Satellite Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT.) or satellite lead to the SATELLITE
INPUT(LNB) located on the rear side of the TV.
“Satellite is only available in 762/772 series”.
Rear side of the TV:
SATELLITE
AERIAL
CABLE
Note: Satellite support is depending on the model.
(only available in LC-42LE772EN / LC-50LE772EN
series)
Installing The Batteries Into The
Remote
• Remove the back cover to reveal the battery
compartment.
• Insert two size AAA batteries. Note the correct
polarity(+ or -). Do not mix old and new batteries.
Replace only with same or equivalent type.
• Place the cover back on.
Remote Control 1 / Remote Control 2
Angle of the remote control unit
Use the remote control unit by pointing it towards the
remote control sensor.
Objects between the remote control unit and sensor
may prevent proper operation.
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock.
In addition, do not expose the remote control unit