Sharp LC-46LD266K - Manual (Page 13)

Connecting a USB device or external devices
10 - - 11
• Cables used to extend the USB device must be certified
as USB 2�0�
• Video playback via a USB device may not be possible or
the playback quality affected if the device data transfer
speed rating is too low�
• File number over 1000 may not be displayed�
• No quickly operation between play / pause /
fast forward / rewind�
• The video might get judder or unsmooth when USB
read/write speed is under requirement(some Full HD
format)�
• Files in USB 1�1 devices may not be played properly�
• Some video file formats may not be played depending
on the file�
Inserting the Smartcard into CA module
In order to receive coded digital stations, a Conditional
Access module (CA module) and a Smartcard must be
inserted into the CI (Common Interface) slot of the TV�
The CA module and the Smartcard are not supplied
accessories� They are usually available from your
dealer�
Inserting the Smartcard into the CA module
1� Carefully insert the CA module into the CI slot
with the contact-side forward�
2� The logo on the CA module must be facing
outward from the rear of the TV�
NOTE
• It takes about 30 seconds to certify the license key
when you insert a Smartcard into the CI+ compatible
CA module for the first time� This process may fail when
there is no antenna input or you have never run “Auto
installation”�
• The CI+ compatible CA module sometimes upgrades
its firmware� You may not receive any TV images before
upgrading� You can only use the power button during
upgrading�
• The CI+ compatible CA module does not allow you to
output any copy protected programmes using monitor
out�
• If the TV displays an update confirmation message
for the Smartcard while receiving CI+ compatible
broadcasts, follow the screen prompts�
• Make sure that the CA module is properly inserted�
Checking CA module information
After inserting and activating the CA module, make
sure the input source is
TV�
NOTE
• This menu is only available for digital stations�
• The content of this menu depends on the provider of the
CA module�
Module: General information on CA module displays�
Menu: Adjustment parameters of each Smartcard
displays�
Enquiry: You can input numerical values such as
passwords here�
HDMI connection
One touch play
• When the TV is in standby mode, it will automatically
turn on and play back the image from the HDMI
source�
Audio return channel (ARC)
The TV can send audio data for video content shown
on the TV to a connected audio device with just one
ARC-compatible HDMI cable� Using this function
eliminates the need to use a separate digital or
analogue audio cable�
Connection for using “Audio return channel”
• You need to use ARC-compatible cables/devices
and connect to the HDMI 1 terminal to activate this
function�
Supported display resolutions
Computer formats (PC)
Resolution
Refresh rate
640 x 480 60Hz
800 x 600 56Hz
800 x 600 60Hz
1024 x 768 60Hz
1280 x 768 60Hz
1360 x 768 60Hz
1280 x 1024 60Hz
Video formats
Resolution Refresh rate
480i 60Hz
480p 60Hz
576i 50Hz
576p 50Hz
720p 50Hz, 60Hz
1080i 50Hz, 60Hz
1080p (HDMI only) 50Hz, 60Hz, 24Hz