Baby Trend 7311 - Manual (Page 12)

Peg Perego
®
Primo Viaggio
®
Please follow the following instructions for proper installation of
your infant car seat.
Installation of Peg Perego
®
Primo Viaggio
®
Infant Car
Seat
1. Place front seat in the reclined position. With one hand grasp
the car seat handle (in its upright, carrying position) and gently
place the seat, so that the baby faces the rear of the stroller, onto
the Snap-N-Go attachment system so that the large groove on
the seat bottom rests on the Snap Bar.
2. Rotate the car seat handle toward the foot end of the seat until
locked into place. Loop the two ends of the Car Seat Strap
(attached to the Snap-N-Go frame) over the car seat handle and
snap the two buckles together (see Figure 2). The fi rst time
you do this, you will need to adjust the length of the strap for
a tight fi t around the car seat. FOR SAFE OPERATION, IT
IS VERY IMPORTANT THAT THE CAR SEAT STRAP
IS ALWAYS TIGHTLY FASTENED AROUND THE CAR
SEAT.
3. Test for secure installation by moving the car seat in all
directions. The car seat should be securely attached to the
stroller.
Removal of Peg Perego
®
Primo Viaggio
®
Infant Car
Seat
1. Unlock the Car Seat Strap and remove both ends from over the
car seat.
2. With one hand, grasp the car seat handle (in its upright, carrying
position) and with your other hand squeeze the grey handle on
the back of the car seat and lift the car seat upward from the
Snap-N-Go attachment system.
Figure 1.
Figure 2.
Snap Bar
Position “I”
Position “5”
12
Cosco ® , Peg Perego ® , Primo Viaggio ® , Evenfl o ® , Cozy Carry ® , On my Way ® , Embrace ® ,
Century ® , Vante ® , Graco ® , Cosco ® Arriva ® and Snug Ride ® are the trademarks of their owners.
They are not associated with Baby Trend, Inc. and no approval or endorsement is implied.