Baby Trend 7311 - Manual (Page 19)

Baby Trend Latch-Loc, Flex-Loc
Forward BT BAR
Figure 2.
Figure 1.
Position “4”
Please follow the following instructions for proper installation of your
infant car seat.
Installation of the Baby Trend
®
Latch-Loc
®
Infant Car
Seat
1. Remove (unscrew) the Snap Bar from the Snap N Go attachment.
2. With one hand grasp the car seat handle (in its upright, carrying
position) and gently place the seat, so that the baby faces the rear
of the Stroller, onto the Snap-N-Go attachment system so that the
large groove on the seat bottom, nearest the head-end of the seat,
hooks over the BT Bar.
3. Feed the Car Seat Straps through the auto belt slots on the infant
car seat and snap the two buckles together (see Figure 2). The fi rst
time you do this, you will need to adjust the length of the strap
for a tight fi t around the car seat. FOR SAFE OPERATION, IT
IS VERY IMPORTANT THAT THE CAR SEAT STRAP IS
ALWAYS TIGHTLY FASTENED OVER THE CAR SEAT.
4. Test for secure installation by moving the car seat in all directions.
The car seat should be securely attached to the stroller.
Removal of the Baby Trend
®
Latch-Loc
®
Infant Car Seat
1. Unlock the Car Seat Strap and remove from over the infant car
seat.
2. With one hand, grasp the car seat handle (in its upright, carrying
position) and with your other hand squeeze the handle on the
footend of the car seat and lift the car seat upward from the Snap-
N-Go frame.
19
Cosco ® , Peg Perego ® , Primo Viaggio ® , Evenfl o ® , Cozy Carry ® , On my Way ® , Embrace ® ,
Century ® , Vante ® , Graco ® , Cosco ® Arriva ® and Snug Ride ® are the trademarks of their owners.
They are not associated with Baby Trend, Inc. and no approval or endorsement is implied.