Sharp EL-1750PIIIGY User Manual
Page 12
10
To Install or Replace Batteries — When the battery
power becomes weak, printing may be halted, and
displayed images may disappear. If such symptoms
are observed, replace the batteries with new ones.
1. Set the power switch to OFF.
2. Remove the battery cover by sliding it in the
direction of the arrow on the cover.
3. Replace the batteries. Be sure that the “+” and “–”
marks on the battery correspond to the “+” and “–”
marks in the calculator. Always put back the 4
batteries at the same time.
4. Put back the battery cover.
Battery: Manganese dry battery, size AA (or R6)
×
4
BATTERY REPLACEMENT
• If the leaked electrolyte gets into eyes, wash off
with clean water, and consult your doctor
immediately.
• If the leaked electrolyte gets on your skin or
clothes, wash off thoroughly with water.
• Remove batteries if not used for prolonged
periods of time.
• Do not leave dead batteries in the unit.
• Do not mix new and used batteries and/or
battery types.
EL-1750PIII(LCO)-Eng
04.9.15, 3:27 PM
10