I n sta l l at i o n – Belkin F1DA104T User Manual
Page 13
11
I N STA L L AT I O N
Connect the Computer:
PS/2 Installation
1. Using an OmniView KVM Cable (Belkin part# F3X1105-XX or
F3X1835-XX-GLD), plug in the male VGA connector to the VGA port
on the computer. Connect the other end (the female connector) of the
VGA cable to the back of the PRO2 labeled "VGA 01".
2. Connect the PS/2 keyboard and PS/2 mouse connectors of the cable to
the keyboard and mouse ports on the computer. Connect the other ends
of the cables to the keyboard and mouse ports located directly underneath
VGA 01 on the PRO2 (Belkin part # F3X1105-XX or F3X1835-XX-GLD).
3. Repeat steps 1 and 2 for each
additional PS/2 computer you
wish to connect.
USB Installation:
Boot the computer you wish to connect via USB as you would normally with
the keyboard, monitor, and mouse connected directly to the computer. After
the operating system finishes loading, connect the PRO2 to the USB computer
using the USB A-to-B cable that is part of your USB KVM Cable (Belkin part#
F3X1962-XX or F3X1895-XX-GLD). Your computer should recognize your
PRO2 and automatically install the HID USB driver if necessary. Once your
computer finishes installing the USB driver, you can power down your
computer to connect it to the PRO2.
VGA
VGA
VGA
VGA
VGA
VGA
VGA
VGA
VGA
08
08
08
USB
USB
USB
USB
USB
USB
USB
USB
07
07
07
06
06
06
06
05
05
05
04
04
04
03
03
03
02
02
02
01
01
01