Blaupunkt SAN FRANCISCO CD70 - Manual (Page 7)

7
ENGLISH
FRANÇAIS
ESP
AÑOL
PORTUGUÊS
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
Note:
If a card that does not belong to the unit (for
example, a bankcard) is inserted, the display
will read “Wrong KC”.
Remove the incorrect card and insert a card
that the unit is able to recognise.
Removing the KeyCard
To unlock the operating panel,
➮
Press the button
1
.
This will open the operating panel.
➮
Use the “slide” to push the card to the
right as far as it will go.
➮
Remove the card from the operating
panel.
➮
Close the operating panel.
Note:
To discourage theft, always remove your Key-
Card before exiting the vehicle and leave the
operating panel open.
For reasons of safety, the operating
panel must be closed whenever the vehi-
cle is in motion.
Replacing / “training” KeyCards
Note:
No more than two KeyCards can be used for
each unit.
If you already have two KeyCards for your unit
and you “train” a third KeyCard, then the unit
can no longer be operated with the KeyCard
that was not used in training.
Theft protection, KeyCard
Your radio comes with two KeyCards.
To replace a lost or damaged KeyCard, con-
tact your Blaupunkt dealer.
If you use two KeyCards, the settings for the
first KeyCard are also used for the second
KeyCard. You can, however, store the follow-
ing functions individually:
Preset stations, beep volume, equaliser set-
tings.
In addition, the last values set for frequency
range, station, scanning time, and switch-on
volume remain stored.
This way, after you insert your KeyCard, the
unit will always be in the basic configuration
that you have chosen.
Inserting the KeyCard
➮
Press the button to open the operat-
ing panel
1
.
➮
Insert the KeyCard as shown in the pic-
ture (Arrow 1) with the contacts facing
downward.
➮
Use the slide to push the card carefully
in the direction shown by the arrow (2)
as far as it will go.
2
1
3
➮
Close the operating panel (Arrow 3).
THEFT PROTECTION