Blaupunkt SAN FRANCISCO CD70 - Manual (Page 8)

8
To “train” a new KeyCard as a replacement
for a lost or unusable KeyCard:
➮
Insert the remaining valid KeyCard and
switch on the unit.
➮
Press the MENU button
8
.
➮
Press the soft key
4
with the display
allocation “KC”.
➮
Press the soft key
4
with the display
allocation “LRN”.
The display will read “LEARN KC”.
➮
Remove the first KeyCard.
The display will read “INSERT”.
➮
Insert the new KeyCard.
The display will read “LEARN OK”.
To exit the KeyCard menu
➮
press the MENU button
8
or the OK
button
5
.
Now the car radio can be used with two Key-
Cards again.
Lost or damaged KeyCards
If all of the KeyCards belonging to a unit have
been lost or damaged, first a new KeyCard
with the master code of the unit must be
“trained”. The master code of the unit is con-
tained in the radio pass.
Always keep the radio pass in a safe
place, but never in your vehicle.
To “train” a new KeyCard, follow the instruc-
tions given in the section “Training a new Key-
Card / entering the master code”.
If necessary, you can use this KeyCard to train
a second KeyCard. For instructions on how
to do this, read the section “Replacing / train-
ing KeyCards”.
New KeyCards can be obtained from your
dealer.
“Training” a new KeyCard /
entering the master code
If you no longer have any valid KeyCards for
your unit and want to “train” a new KeyCard:
➮
Insert a new KeyCard that is unknown
to the unit.
➮
Close the operating panel.
➮
Turn off the unit if necessary.
➮
Simultaneously hold down the TUNE
button
>
and the second soft key
4
from the top on the left side
2
.
The display will read “0000”.
Enter the four-digit master code from the ra-
dio pass as follows:
➮
Use the / buttons
7
to enter the
respective digits of the master code.
Press the buttons until the desired num-
ber appears on the display.
➮
Use the buttons
7
to move from
one digit to the next during input.
➮
Once the master code is displayed cor-
rectly, press the OK button
5
.
The new KeyCard is accepted when the unit
switches to play.
Optical theft protection indicator
(LED)
The ON/OFF button and the CD bay illumi-
nation can be set to blink when the unit is off
and the KeyCard has been removed. To do
this, the menu setting “LED” must be set to
“ON”.
➮
Press the MENU button
8
.
➮
Press the soft key
4
with the display
allocation “KC”.
➮
Press the soft key
4
with the display
allocation “LED”.
The display will show the current status “LED
ON” or “LED OFF”.
THEFT PROTECTION