Neff S51E50X1GB - Manual (Page 22)

en Operating the appliance
22
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme by 3, 6 or 9 hours.
1. Switch on ON/OFF switch (.
2. Keep pressing the Preselected
starting time button 0 until the
appropriate display 3h, 6h or 9h is lit.
3. Press START button h, timer
programming is activated.
4. To delete the preselected starting
time, keep pressing the Preselected
starting time button 0 until none of
the displays 3h, 6h or 9h is lit.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when
neither of the two displays ` or X
is lit.
The end of the programme is also
indicated by an acoustic signal.
The buzzer volume can be set in 4
stages. Accordingly 0, 1, 2 or 3 displays
are lit (see water hardness table).
Factory setting: 2. This function can be
changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
4. Release buttons.
5. Keep pressing button > P until
the salt refill indicator )* and rinse
aid refill indicator )" flash.
6. Release buttons.
The refill indicators )* and )"
flash and the displays # and +
are lit (= Setting 2). The set buzzer
volume can be heard.
To change the setting:
1. Press the button < H until
the required setting has been
selected.
2. Press START button h.
The displays go out. The selected
setting is saved.
3. Close the door.
Note
To save energy, the dishwasher
automatically switches off after the end
of the programme.