Bosch 4410L - Manual (Page 20)

20.
Mounting Applications
Setting Main Handle in
Desired Position
The switch handle can be positioned in any of four
different orientations, depending on the cutting
situation and user preference:
a. Vertical b. 45° Left c. Horizontal d. 45° Right
To reposition the main handle:
1. Release handle lock clamp.
2. Pull and hold handle rotation release lever
3. Rotate handle to desired location.
4. Let go over release lever to set handle into
place. Release lever will retract down only in
one of the four (4) positions
Note: Power switch can not be actuated unless
release lever is retracted down. Do not attempt to
switch tool on between handle position, damage may
occur.
5. Lock the handle clamp.
Adjusting the Four-Position Handle
Lock Clamp Tension
1. Open handle lock clamp.
2. Using 1.5 mm Allen wrench, increase tension by
turning both setscrews 1/4 turn to the left, tighten
by turning to the right. Always adjust both
setscrews by the same amount.
3. Close handle lock clamp.
4. Check the tension.
Adjusting the Four Position Switch Handle
Portable Mounting Using Clamps
If necessary, clamp the miter saw to a workbench or
table top by placing two (2) or more “C” clamps on
the clamping areas and secure.
NOTE: Be careful not to place clamps over the base
extension clamping levers.
Mounting with clamps will prevent access to some
wide miter angles.
Clamping Areas
Clamping
Areas
Handle
Lock
Clamp
Handle
Rotation
Release
Lever
Figure: Portable Mounting Using Clamps
Figure: Setting Main Handle Position
a. b. c. d.
Transporting, Placement & Mounting