Bosch WTMC 652SUC - Manual (Page 27)

27
Start/Stop" indicator light does not
illuminate.Wrinkle block" indicator
lights.
The display shows 000".
Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.
Degree of drying has not been reached
or the drying time is too long.
Moisture sensor dirty. Clean moisture sensor as described on page 25.
Switch off/switch on again. y g g
Display may indicate E:03".
Exhaust air duct is blocked or too long. Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on page 10.
Switch off/switch on again.
Lint filter dirty. Clean filter as described on page 25.
Switch off/switch on again.
Laundry was too wet. Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Unsuitable program selected. Select program with aid of the program selection
table (see page 21). Switch off/switch on again.
Maximum drying time was exceeded. Clean lint filter (see page 25).
Check exhaust air extraction.
Spin laundry at a higher speed in your washer.
Motor limit temperature was exceeded. Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
Degree of dryness not correct set. Change settings for degree of dryness, see page 19
Lint filter LED is blinking after lint filter
has been cleaned
Blinking of lint filter LED is not an indication of a
problem. It is used only as a reminder.
No action required. Light will stop blinking.
SERVICE and REPAIR
d CAUTION d
CAUTION - Label all wires prior
to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous
operation. verify proper
operation after servicing.
The Bosch dryers require no special
care other than the care and
cleaning noted above.
i If you are having a problem with
your dryer, before calling for
service please refer to Table on
page 26, following.
If service becomes necessary,
contact your dealer or installer or an
authorized service center. Do not
attempt to repair the appliance
yourself. Any work performed by
unauthorized personnel may void
the warranty.
If you are having a problem with
your Bosch dryer and are not
pleased with the service you have
received:
- First, please contact your
installer or the Bosch
Authorized Service Contractor
in your area and explain to
them why you are not satisfied.
This will usually correct the
problem.
- If after working with your
installer or service person the
problem still has not been
resolved to your satisfaction,
please let us know by either
writing to us at,
BSH Home Appliances
5551 McFadden Avenue
Huntington Beach, CA 92649
or, calling us at
1Ć800Ć944Ć2904.
Please be sure to include, if writing,
or have available, if calling, the
following information:
- Model Number
- Serial Number
- Date of Original Purchase
- Date Problem Originated
- Explanation of Problem
Also, if writing, please be sure to
include a daytime telephone
number and a copy of the sales
invoice.
You will find the model number and
serial number information on the
rating plate located on the inside of
the front panel.