Using phone book – Beko BD 220 User Manual
Page 13
Switchi
ng your handset On or Off
- Press and hold TALK-OFF button to power off the handset.
- Press TALK-OFF button to p
ower on the handset again.
Page function
If you lose or misplace your handset you can press the Page on
base to relocate it.
- Press the Page button on the base. The paged handset will
ring. The In Use LED on the base will flash and INT icon will
blink in the LCD screen of handset.
- To stop paging, press the PAGE button on the base again, or
press any key on the handset.
* If you do not stop the paging ring, it will stop automatically
after 30 seconds.
Out of range warning
During standby:
- The range symbol on the display flashes when your handset
loses its link with the base. When your handset re-establishes
its link with the base the range symbol becomes steady.
During a call:
- When the handset is too far away from the base during a
call, an alert tone (if you sent the alert tone on) is repeatedly
sounded in the handset. Bring the handset closer to the base so
that the signal gets stronger. If you do not bring the handset
back in range, your call will be disconnected.
○○○○○○○○○○○○○○○○
○○○○○○○○○○○○○○○○○
- 13 -
USING PHONE BOOK
Not
e: You can store up to 25 phone records in the handset
with up to 12-characters for name, and up to 25 digits for
numbers. You can add new numbers, modify a number,
delete an entry or all entries in the phonebook. or look up a
number in the phonebook memory and dial out. You can set a
number as a VIP number for yourVIP person. When you
receive the VIP call from the related VIP person, you will hear
your specified VIP ringer melodyl. This VIP function is only
available when you subscribed to a Caller ID service. .
Storing an entry in the phone book
1. Press OK/Menu button. PHONEBOOK is displayed.
2. Press OK/Menu button again. ADD is displayed.
3. Press OK/Menu button again. NAME? is displayed.
4. Input name (max. 12 characters) from the alphanumeric
keypad.
** Using the handset keypad to enter characters:
-
You can enter characters by pressing the key with
the required character on a number of times
according to its position in the string of characters
on the key legend. E.g. for C, press 2 three times;
for S, press 7 four times, for J, press 5 once.
-
If you wish to enter successive characters which
are on the same key, you must wait for the cursor
to move to the next location on the screen before
entering the next character.
-
To enter a space, press 1 once. To enter --, press
1 twice. To enter 1, press this key thrice.