Beko BD 220 User Manual

Page 8

Advertising
background image

Charging the batteries

Your handset needs battery to operate. During the first use of
your phone, it is recommended that the handset is left over on
charge overnight to ensure maximum in-use time.
1. Only use the rechargeable batteries supplied with your
phone.
2. Install the rechargeable batteries into the rear of your
handset. MAKE SURE you insert the batteries in correct
polarity.
3. Position the battery cover over the rear of the handset and
slide into place.
4. Place the handset on the base unit to charge.
5. The red LED CHARGE light on the base unit indicating that
the handset is charging, but it will not go out even if the
battery if full - it will light up whenever the handset is on the
base cradle.
NOTE : 1) If the charge LED on the base do not light up,
reposition the handset in the base unit ensuring the charging
points contact. 2) Regular cleaning is necessary for base and
handset charge contacts with clean dry cloth to maintain
conductivity of the contacts.

Electrical Safety

1. DO NOT install the base unit near a sink, bath or shower or
anywhere else where it could get wet. Electrical equipment
can cause serious injury if used while you are wet or
standing on water.
2. If the base unit ever falls into water, DO NOT retrieve it until
you have unplugged the AC mains power adaptor and the
telephone line plug from the telephone wall socket.

3. DO NOT allow the handset to come in contact with water.
4. DO NOT open the handset or the base.
5. DO NOT allow the charging contacts or the battery to

come in contact with electrical conductive materials such
as metals, rings, paper clip, key, etc.

6. MAKE SURE you insert the batteries in correct polarity.
7. NEVER USE your DECT phone in the open air during a

thunderstorm - unplug the base unit from the telephone
line and the AC mains socket where there are storms in
your area. Damage caused by lighting may likely happen.

8. If your DECT phone is not to be used for long period of

time, disconnect the main AC power adaptor from the AC
power socket and the telephone line from the telephone
wall socket.

Emergency calls

Your DECT phone need mains power. So you cannot use for
placing a call during AC power failure.
Thus, a basic phone that do not need AC mains power is
needed to place an emergency call during power failure.

○○○○○○○○○○○○○○○○○

○○○○○○○○○○○○○○○

- 8 -

Advertising