Brady 200M-e 300 - Manual (Page 26)

16 Bradyprinter 200M-e and 200M-e 300 User’s Guide
&RQILJXULQJ WKH 6RIWZDUH RU 3ULQWHU 'ULYHU
Many printer settings may also be controlled by your printer’s driver or
label preparation software. Please refer to the driver or software
documentation for more information.
Table 1
Press Display Shows Action/Explanation
— PRINTER READY Normal printer operation.
DARKNESS
Press the (+) or (–) keys to increase or decrease the print
darkness setting. (You may need to change this setting when you
print your label.)
PRINT MODE
Press the (+) or (–) keys to select tear-off, peel-off, cutter, or
rewind mode.
MEDIA TYPE
Press the (+) or (–) keys to select continuous or non-continuous
media type. (If you choose continuous media, you must also
include a label length instruction in your label format.)
SENSOR TYPE
Press the (+) or (–) keys to select transmissive or black mark
sensing mode. Unless your media has black marks on the back,
leave your printer at the default setting (web).
PRINT METHOD
Press the (+) or (–) keys to select thermal transfer (if you are using
ribbon) or direct thermal (no ribbon).
MAXIMUM LENGTH
Press the (+) or (–) keys to set the value that is closest to, but not
less than, the length of the label you are using.
SAVE SETTINGS
Press the (+) or (–) keys to select:
PERMANENT — saves changes when the power is turned off.
Press SETUP/EXIT to accept the selection.
— PRINTER READY You have exited the configuration mode and are now ready to
calibrate the printer.