Optimising the lifetime of the batteries, Preparing for use, Freezing the leg skin cooler – Philips Satinelle Ice Premium Depiladora User Manual

Page 9: Using the appliance, General information about epilation

Advertising
background image

optimising the lifetime of the batteries

- After you have charged the appliance for the first time, do not

recharge it between epilating or shaving sessions. Continue to use it

and only recharge it when the battery is (almost) empty.

- Discharge the batteries completely twice a year by letting the motor

run until it stops.

- If the appliance has not been used for a long time, it must be

recharged for 16 hours.

Preparing for use

Freezing the leg skin cooler

1

Put the skin cooler WITHOUT the insulating sleeve in the freezer

or freezing compartment (***) at least 4 hours before you start to

epilate. When the fluid has turned completely blue, the skin cooler

is ready for use.

Make sure the outside of the skin cooler is completely dry before you

freeze it.
Tip: You can store the skin cooler in the freezer permanently.

using the appliance

general information about epilation

- Epilation is easier just after a bath or shower. Make sure your skin is

completely dry when you start to epilate.

- When you use the appliance for the first time, we advise you to try it

out on an area with only light hair growth. This helps you get

accustomed to the epilation process.

- To epilate hairs longer than 10mm: (Fig. 2)

1 shorten the hairs to a maximum length of 10mm with a trimmer. In

this case, you can start to epilate right away.

2 shave the hairs completely. In this case you can start to epilate after a

few days (the hairs must be at least 0.5mm long).

- Your skin may become a little red and irritated the first few times you

use the epilator. This phenomenon is absolutely normal and quickly

EnglisH

9

Advertising