Black & Decker BDN200 - Manual (Page 4)

4
• Do not use tool without safety warning label. If
label is missing, damaged or unreadable, contact
1-800-544-6986 for a replacement. (Fig. 9)
• Only use parts, fasteners and accessories
approved by Black and Decker.
• Connect tool to air supply before loading
fasteners, to prevent a fastener from being fired
during connection. The tool driving mechanism may
cycle when tool is connected to the air supply.
(Fig. 10)
• Always assume the tool contains fasteners. No
horseplay. Respect the tool as a working
implement. (Fig. 11)
• Operator and bystanders should wear hard hats
to safeguard against possible injuries. (Fig. 12)
• Do not load fasteners with trigger or safety
depressed, to prevent unintentional firing of a
fastener. (Fig. 13
)
• Remove finger from trigger when not driving
fasteners. Never carry tool with finger on trigger. In
“Contact Actuation Mode” tool will fire a fastener if
safety is bumped while trigger is depressed.
(Fig. 14)
Fig. 9
Fig. 11
Fig. 10
Fig. 12
Fig. 13
Fig. 14
492848-00,BDN200 NAILER 2/2/06 1:35 PM Page 4