Mounting the powerstar, Water connections – Bosch AE115 User Manual

Page 4

Advertising
background image

Mounting the Powerstar

WARNING:

The heater must only be installed in the orientation shown in Diagram 1 i.e., mounted in a vertical position
with the water fittings located at the bottom of the heater. Under no circumstances should the heater
be mounted differently.

•

Undo the retaining screws on the front cover and take the cover off the heater. Hold the back plate
in position against the wall and mark the four mounting holes

•

Drill the holes and secure the heater using the four wood screws supplied.


Diagram 1

AE115 Unit AE125 Unit


Water Connections

WARNING:

Do not install a non-return check valve within 10 feet of the inlet.

WARNING:

Do not apply heat or solder to connections or pipe if they are already connected to the unit.

DISCLAIMER:

In the Commonwealth of Massachusetts a pressure relief valve shall be installed on the cold water side by
a licensed plumber. (MGL 142 Section 19, Approval number P1 -09-25)

•

The heater must be connected directly to the main cold water supply and not to pre-heated water.
(The inlet water temperature must not be greater than 86°F.)

•

The heater must be installed with shutoff valves on both the inlet and outlet connections.

•

It is recommended that you use ¾ inch or ½ inch copper or high -pressure flex connections.

4

Advertising
This manual is related to the following products: