Brinkmann Series 2630 - Manual (Page 25)

24
Step 18
Place the stainless steel heat
shields on lower level of grill body
assembly directly above burners.
Step 19
Place stainless steel cooking grills
on support ribs directly above
stainless steel heat shields.
Step 20
Place warming rack in slots above
stainless steel cooking grills.
OFF
HIGH
LOW
OFF
HIGH
LOW
OFF
HIGH
LOW
OFF
HIGH
LOW
MAXIMUM
SIDE BURNER
LOAD = 15 lbs.
1. Read and follow all warnings and instructions in owner’s manual before lighting. 2. Open lid before lighting burner.
3. Make sure all control knobs are in the OFF position.
4. Select the burner to be lit. Push and turn the control
knob of that burner to HIGH.
5. Press the electronic igniter and hold for 3-5 seconds to light burner. 6. If burner does NOT ignite immediately, turn control knob to OFF, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
7. Repeat Steps 4-6 for lighting each burner. Always use electronic igniter for lighting each burner. 8. Refer to owner’s manual for match lighting procedure.
9. For assistance, call 1-800-527-0717.
10. To turn off, turn control knobs clockwise until it locks in OFF position.
GRILL LIGHTING INSTRUCTIONS: SIDE BURNER
LIGHTING
INSTRUCTIONS:
1. Follow Steps 1-3 in GRILL
LIGHTING
INSTRUCTIONS.
2. Push and turn SIDE BURNER
control knob to
HIGH.
3. Follow Steps 5-10 in GRILL
LIGHTING
FOR OUTDOOR USE ONLY
50 100
200 300
400
500 °F
Warming Rack
Cooking Grills
Stainless Steel
Heat Shields
Pro Series 2630 (Assembled)