Philips Satinelle Depiladora - Manual (Page 10)

1 Slide the insulating sleeve onto the skin cooler. (Fig. )
The insulating sleeve prevents an unpleasant sensation of coldness in your
hand while you use the appliance. It also keeps the skin cooler cold as
long as possible.
Sometimes the pivoting cooling head freezes onto the skin cooler and
does not move when you take the skin cooler from the freezer. The
pivoting cooling head starts to pivot again after you have passed it over
your leg a few times.
 Snap the appliance onto the skin cooler (Fig. 5).
 Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
 Select the desired speed to switch on the appliance (Fig. 6).
Select speed I for areas with little hair growth and for areas where bones
are located directly beneath the skin, such as knees and ankles.
Select speed II for larger areas with stronger hair growth.
5 Stretch your skin with your free hand to make the hairs stand
upright.
6 Place the appliance perpendicularly onto the skin with the epilating
head pointing forward. Move the appliance against the direction of
hair growth at a moderate speed. (Fig. 7)
Make sure both the epilating discs and the skin cooler are in proper
contact with the skin.
Press the appliance lightly onto the skin.
If you are not completely satisfied with the epilation result, try
moving the epilator more slowly over your skin.
7 Use the tab on the bottom end of the appliance to remove the
appliance from the skin cooler (Fig. 8).
Epilating with the skin cooler for underarms and bikini line
The special skin cooler for the underarms and the bikini line reduces the
number of active epilating discs. Combined with the large cooling surface,
this skin cooler makes epilating sensitive areas less painful. You get the best
results when the hairs are not too long (max. 1cm).
,
EnglisH 10
4203.000.3665.1.indd 10 23-10-2006 10:48:05