Philips Satinelle Depiladora - Manual (Page 8)

Do not charge the appliance for more than  hours.
1 Make sure the appliance is switched off while charging.
 Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
The charging light goes on and stays on to indicate that the
appliance is charging.
The charging light does not go out or change colour when the
appliance is fully charged.
 For more convenient charging, you can put the appliance in
the stand (‘click’) (Fig. ).
optimising the lifetime of the batteries
After you have charged the appliance for the first time, do not
recharge it between epilating or shaving sessions. Continue to use it
and only recharge it when the battery is (almost) empty.
Discharge the batteries completely twice a year by letting the motor
run until it stops.
Do not keep the appliance plugged into a wall socket all the time.
If the appliance has not been used for a long time, it must be
recharged for 16 hours.
Preparing for use
Freezing the skin cooler
1 Put the skin cooler WITHOUT the insulating sleeve in the freezer
or freezing compartment (***) at least  hours before you start to
epilate. When the fluid has turned completely blue, the skin cooler
is ready for use.
Make sure the outside of the skin cooler is completely dry before you
freeze it.
Tip: You can store the skin cooler in the freezer permanently.
,
-
-
-
-
EnglisH 8
4203.000.3665.1.indd 8 23-10-2006 10:48:04