Philips Afeitadora NIVEA FOR MEN - Manual (Page 9)

2 Press the on/off button to switch on the shaver.
3 Make sure the shaver is sufficiently charged (see chapter ‘Preparing for use’, section ‘Charge
indications’).
4 Gently move the shaving unit in circles over your skin and press the shaving conditioner
button until there is enough shaving conditioner on your skin for a comfortable
shave. (Fig. 19)
- When you release the shaving conditioner button, the appliance stops dispensing conditioner.
- If you briefly press the shaving conditioner button, the appliance automatically applies a certain
amount of conditioner.
- Press the shaving conditioner button again to apply more shaving conditioner during shaving to
ensure that the shaving unit continues to glide smoothly over your skin.
Note: The shaving conditioner button only works when the shaver is switched on.
Note: This shaver can be used in a way similar to a razor blade: you can use the shaver on a wet face.
Unlike a conventional electric shaver, this appliance has no hair chamber that collects stubble. To prevent
stubble from falling on your clothes, apply sufficient shaving conditioner while shaving.
5 Thoroughly clean the shaver after every use (see chapter ‘Cleaning and maintenance’).
6 Slide the protection cap onto the shaver to prevent damage (Fig. 20).
tips for optimal gliding and a smooth shaving result
- Gently move the shaver in circles over your skin.
- Do not exert too much pressure on the shaver, as this may cause skin irritation.
- To ensure proper gliding, apply shaving conditioner regularly.
- You can also use the shaver in the bath or shower.
trimming
Note: Because of the new open design, you hear the cutting action of the trimmer more clearly than with
other trimmers. This is normal.
1 Pull the shaving unit off the shaver (Fig. 21).
2 Take the trimmer out of the trimmer holder on the charger and put it on the shaver
(‘click’) (Fig. 22).
3 Press the on/off button to switch on the shaver.
4 Use the trimmer to groom your sideburns and/or moustache.
5 Thoroughly clean the trimmer after use (see chapter ‘Cleaning and maintenance’).
6 Remove the trimmer and put it back into the trimmer holder.
7 Put the shaving unit back onto the shaver (‘click’) (Fig. 23).
8 Slide the protection cap onto the shaver to prevent damage (Fig. 20).
cleaning and maintenance
cleaning
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or
acetone to clean the appliance.
Shaver/trimmer
Clean the shaver and the trimmer after every use.
Be careful with hot water. Always check if the water is not too hot, to avoid burning your hands.
EngliSH 9