Bryston 60 - Manual (Page 2)

GENERAL INSTRUCTIONS
Setup Recommendations:
Description:
General Information:
Thank you for choosing a Bryston
product. We would welcome any comments
or suggestions you may have regarding the
operation of your amplifier. We consider our
customer to be Bryston,s most important re-
source and your opinion is very much appre-
ciated. In the unlikely event you have a prob-
lem with your amplifier and must return it for
service please keep the original box and all
packaging material.
The Bryston Po werPac 60/120/300
are high quality modular single channel
60/120 /300 watt power amplifier intended for
use in applications where portability, quality
and flexibility are of prime importance.
The PowerPac is a perfect choice for
use as a modular power amplifier which can
be attached directly to the rear of your loud-
speaker . It can also be bolted on the wall, or
in the wall, for utilization in audio/video sur-
round systems (left/right/center/rears) where
a non-conspicuous power module is required.
Another application would be in multi-room
audio systems where single or multiple ampli-
fiers are needed to provide music to other
rooms.
We recommend that you do not place
the amplifier in a totally enclosed area. Allow
some space at the top, sides as your Bryston
amplifier relies on convection cooling and
some air flow is desirable.
Make sure the power switch on the
front panel of the amplifier is in the off (out)
position. Plug the power cord into the front
panel of the amplifier, then insert the male
end into the wall outlet.
All Bryston amplifiers contain high
quality, dedicated circuitry in the power sup-
plies to reject RF, line spikes and other
power-line problems.
Bryston power amplifiers do not re-
quire specialized power line conditioners.
Plug the amplifier directly into its own wall
socket.
Connect your loudspeakers ensuring
that the positive (red) and ground (black) ter-
minals on your amplifier are connected to the
positive and ground terminals on your loud-
speakers.
Note: Make sure that the front panel
switch for choosing balanced or non-
balanced is in the correct position.
The Bryston PowerPac 60 monaural
amplifier consist of two of Bryston’s custom
power transistors as output devices. The
power output is 60 Watts @ 8 Ohms.
T he Bryston PowerPac 120 monaural
amplifier consist of four of Bryston’s custom
power transistors as output devices. The
power output is 120 Watts @ 8 Ohms.
T he Bryston PowerPac 300 monaural
amplifier consist of eight of Bryston’s custom
power transistors as output devices. The
power output is 300 Watts @ 8 Ohms.
Dimensions PP60: (LHW) 12 X 1.8 X 7.1 Inches,
30.5 x 4.6 x 17.9 cm.
Weight 5.7 Lbs/2.6Kg.
Dimensions PP120: (LHW) 12 X 4.3 X 7 Inches,
30.5 x 10.9 x 17.8 cm.
Weight 10.6 Lbs/4.8Kg.
Dimensions PP300: (LHW) 17 X 4.5 X 8.4 Inches,
43 x 11.5 x 21 cm.
Weight 23 Lbs/10.5Kg.